Rue Mohr🇨🇦's banner
Rue Mohr🇨🇦's profile picture

Rue Mohr🇨🇦

@RueNahcMohr13,516 subscribers

1 Techie. Electronics, Programming, Mechanical. I do it for fun, but I walk a lonely road.

Shorts

I know you like that code editor you use, but, can it do this? #startawarontwitter

I know you like that code editor you use, but, can it do this? #startawarontwitter

523,328 Aufrufe

This is the cnc I made in 1997, its the 2nd cnc machine I built. The motion control is all done in a program written in C that runs on the 386. Each motor is operated via 4 bits of a parallel port (uses 2 ports) Its job today is to slot some parts.

This is the cnc I made in 1997, its the 2nd cnc machine I built. The motion control is all done in a program written in C that runs on the 386. Each motor is operated via 4 bits of a parallel port (uses 2 ports) Its job today is to slot some parts.

87,181 Aufrufe

ok that is a LOT more responsive than I thought it would be, trimming up the motion from a gyro might have to be done carefully. might need a filter too?

ok that is a LOT more responsive than I thought it would be, trimming up the motion from a gyro might have to be done carefully. might need a filter too?

68,403 Aufrufe

If you can't do something useful, do something else. :/

If you can't do something useful, do something else. :/

21,461 Aufrufe

Videos

Keine weiteren Inhalte verfügbar