Video wird geladen...

Video konnte nicht geladen werden

Zur Startseite

B737 FREE-FALL (GRAVITY) GEAR EXTENSION 😮‍🔥 No hydraulics? No problem 😎 On the Boeing 737, pilots can drop the landing gear using gravity. Pull the handle → doors unlock → gear falls into place by weight and airflow. No motors. No power. Just physics doing the job. When everything...

21,009 Aufrufe • vor 6 Monaten •via X (Twitter)

0 Kommentare

Keine Kommentare verfügbar

Kommentare vom Original-Post werden hier angezeigt

Ähnliche Videos

Why the 737 landing gear lever has an “OFF” position ✈️ It’s a question I get asked quite often and understandably so! “OFF” isn’t a logical position for the landing gear! The landing gear is retracted into the belly of the aircraft using hydraulic pressure. Once the gear is fully up, mechanical uplocks hold the gear safely in position. However, with the lever in the UP position, hydraulic pressure is still being applied to the system. This is unnecessary now that the gear is being held up with mechanical latches and places extra demand in the hydraulic pumps. So, once the gear has been retracted, the pilots will move the gear lever from UP to OFF as part of the after takeoff checklist. This simply removes hydraulic pressure from the retract lines. When the pilots configure the aircraft for landing, we move the landing gear lever from OFF to DOWN. This action releases the mechanical up locks and the gear is lowered using a combination of hydraulic pressure, gravity and air loads. Once the gear is fully down and locked, a green light - one for each set of wheels, will illuminate. Should the primary gear down sensors fail, we have a second set of green, gear down indicators on the overhead panel. As long as the gear is indicating down and locked on either the primary or standby indicator, the gear is down and locked and safe to land on 👍 In the very unlikely event that the gear won’t lower normally using the landing gear lever, we have a standby gear lowering system which allows the crew to manually release the gear uplocks and allow gravity to lower the gear - see my reel showing that system in operation . With airlinepilotperformance

aircraftmaintenancengineer

19,786 Aufrufe • vor 29 Tagen

😎🤌 According to Bob Lazar, UAP operate using a gravity wave-based propulsion system that distorts space-time rather than using conventional thrust 👽🛸 The craft generate power and gravity waves through a reactor fueled by a stable isotope of Element 115. In the reactor, Element 115 is bombarded with protons, briefly becomes Element 116, decays, and releases small amounts of antimatter. This antimatter annihilates with matter to produce enormous energy (near 100% efficient), which powers the craft and also creates a unique Gravity A wave (a micro-scale gravity field Lazar says is an extension of the strong nuclear force). This Gravity A wave forms around the reactor at the top of the craft. A waveguide channels it downward into three gravity amplifiers arranged in a triangle at the base. These amplifiers run at full power at all times and can phase-shift the wave (0° to 180°) to control direction and strength. By focusing and amplifying the gravity wave, the craft creates a powerful, localized gravitational distortion: - It bends/warps space-time in front of the vehicle. - This effectively pulls the destination toward the craft (instead of pushing the craft forward through space). Operation modes: - Omicron mode (hovering/low speed): Amplifiers point downward → craft balances/sits on its own gravity field (explains the characteristic wobble/bobbing seen in many videos). - Delta mode (high speed/travel): Amplifiers point forward → extreme space-time warping for rapid movement. Key effects: - No inertia (occupants feel no acceleration). - Time dilation near the craft. - Optical distortion (gravity lensing can make the craft appear blurry, shimmering, or invisible). In essence, the craft "falls" toward its target by warping space ahead of it, allowing extreme speeds, sharp turns, and interstellar travel without conventional motion or time dilation issues for the occupants. (#UAP #UFO #UFOSighting)

★ UAP Luigi ★ 👁️⃤ 🇺🇸 👽MJ12 SOM1-01

43,212 Aufrufe • vor 7 Monaten

THE TOWN THAT VANISHED GRAVITY FALLS OREGON 1967 Long before the animated series made it famous, Gravity Falls was a real place—and its disappearance remains one of America’s most baffling occult mysteries. In the summer of 1967, siblings Mark and Dina Pines were sent to stay with their great-uncle Harold Pines in a quiet Oregon forest town officially named Gravity Fall. The town had everything: a sheriff’s office, a school, a lumber mill, and nearly 900 residents. But everything changed the day Mark discovered a leather-bound book, wrapped in chains and animal hide, hidden beneath a loose floorboard in his uncle’s cabin. Inside were unrecognizable symbols, ritual instructions, and horrifying sketches of creatures that defied biology. When Harold saw the book, he trembled and whispered, “They were never supposed to be let out.” Within days, Gravity Fall descended into chaos. Residents reported shadows with no source, footprints ending mid-air, and voices calling their names from the trees. Then, during a violent summer storm, all communication ceased. Roads buckled. Power failed. When authorities arrived two days later, the entire town was gone—not destroyed, not flooded, but erased. No buildings. No cars. No bodies. Just untouched forest, as if the town had never existed. Mark and Dina were found 40 miles away, dehydrated and confused, with no memory of the town, the book, or their uncle. Within a year, Gravity Fall was removed from every official U.S. map. To this day, the book has never been recovered—and no one knows what was unleashed that summer. Was it a government cover-up? A dimensional rift? Or something far older, awakened by forbidden knowledge?

SANTINO

613,549 Aufrufe • vor 7 Monaten