Skip navigation
Claudeで制作してみている切削シミュレータ!
0:00 / 1:20

Claudeで制作してみている切削シミュレータ!

テルえもん

@teruki_obara5.6K followers

Visit on X
335 likesDownloadOriginal post

26,370 views

Claudeで制作してみている切削シミュレータ!

9 Comments

Comments from the original post on X (Twitter)

  • JOKI @ 投資日記's profile picture

    @joki_SQB

    さすがです。NCで見たいと妄想してます。 私のはまだ1日か2日しか壁打ちしてないので今はまだ軌跡を見る所までです。プロマニを覚えさせる時間と課金コストを考えればここまでならソフトを買った方がいいんですけどね。

    5 likes

  • テルえもん's profile picture

    @teruki_obara

    Gコードを学習するツールは搭載させてはいました。実務的なGコードで切削シミュレーションができたら良いですね。

    4 likes

  • RobitOverload's profile picture

    @10_X_eng

    I would probably ditch the swarf or make it configurable. Otherwise this is dope. Is it open source? can I use it in VibeCAD?

    2 likes

  • Drさのすけ@'s profile picture

    @burainokan

    Github で公開してほしい逸品ですね

    2 likes

  • Chariot's profile picture

    @da_chariot

    following!

    1 like

  • 🌕's profile picture

    @Adam__YY

    Astra can 1 shot it in 1 prompt dont bother

  • JorJorWale's profile picture

    @JorJorwale

    Make the tool breakable with excessive force.

  • J M's profile picture

    @jmengvector

    have you compared it with a real cut yet?

  • M.Bora Bulut's profile picture

    @MithatBora

    çok iyi