#_microgear3 007 ウォームギアを作りました。モーターとシャフト以外のグレーの部分は3Dプリンタで出力したものです。 ギアのモジュールは0.2、モーターはステッピングモーターです。
@diorama11115.4K followers
10,387 views #_microgear3
13 Comments
Comments from the original post on X (Twitter)

@Z6EgW1ayPx3847
まったく同じことしてます
3 likes

@diorama1111
😲おおお!

@NahIdTrade007
what is the size and model of the motor? it looks like it is small than the 3.2mm motor
2 likes

@diorama1111
The diameter of this stepper motor is 3.9mm, and the length of the motor body excluding the shaft is 8.6mm. I don't know its model number, and it appears to be no longer available for purchase.
3 likes

@furimabuppan
うちもモジュール0.2で試しましたが、歯先円直径は2.4mmで回転中の摩擦熱が意外に上がりました。モーターは3.7mm径のステッピングで回していました。
1 like

@diorama1111
私は短時間しか動かしていないので摩擦熱は気付きませんでしたが、積層痕の部分がこすれる方向に回すと若干音がうるさくなるので熱を持つかもしれません。

@furimabuppan
詳しくありがとう助かる!

@higharrow1111
モジュール0.2のギアまで3Dプリンタで出せるんですね…!小さいのにちゃんと動いてるのすごいです。3Dプリンター興味あるんで続きも楽しみにしてます

@diorama1111
ありがとうございます! 意外にもあっさり動作しました。さらに小さいモジュールのギアに挑戦しています!
1 like

@Emlwny
Beautiful 😍 Any thoughts for future implications?

@diorama1111
I hope to be able to make tiny gears and bodies for small RC cars using the 3D printer.

@jikokoutei2025
3Dプリンタに興味があります。ラズパイやってるので自分で工作したりするとなかなかよい入れ物がなくて苦労してますので覚えたいの!

@diorama1111
私も3Dプリンタを使い始めたばかりなので練習として簡単な形状から作ってます!