Video wird geladen...

Video konnte nicht geladen werden

Zur Startseite

Microphone Shaped Charge Conspiracy Theory It is not improbable, it is impossible to have killed Charlie Kirk. The first graphic depicts the maximum size of the charge that could theoretically fit inside of the microphone, assuming it was a Rode Wireless II (1.8 × 1.7 × 0.8 inches). The...

69,668 Aufrufe • vor 18 Tagen •via X (Twitter)

0 Kommentare

Keine Kommentare verfügbar

Kommentare vom Original-Post werden hier angezeigt

Ähnliche Videos

Using the standardized formula of penetration depth of shaped charges with the density of human flesh we have determined the exact charge needed to penetrate the sternum and reach the C7 vertebrae. With around 2 grams of PETN copper and lead fragmentation could reach the C7 vertebrae matching the reports from the medical examination. This also matches the energetic release mapped with the modified pixel flow analysis which pinpointed the epicenter in the attached video. Additionally, for this shaped charge to have maximum performance a standoff distance of 2cm would be needed. This could be accomplish by a preliminary charge to blow open the case of the wireless microphone to create some distance between it and the target. This preliminary charge can be seen in the subtitle movement of the magnetic clasp across his chest before the shaped charge is detonated which causes the main wound channel. The slight movement of the shirt collar preceded the shaped charge force which blew the necklace up and over his head from the expansive gas escaping from the shaped charge as it detonated. The wound from this shaped charge would have stopped his heart in under 2 seconds which also explains the bleeding patterns we witnessed from the neck wound. (More on this later) To calculate the explosive charge needed to penetrate 14 cm of a material with a density of 1060 kg/m³, we use the same hydrodynamic theory from *Fundamentals of Shaped Charges* as in the previous calculation. The penetration depth \( P \) for a conical shaped charge is given by: \[ P = k \cdot D \] where: - \( P \) is the penetration depth (in cm), - \( D \) is the cone diameter (liner base diameter, in cm), - \( k \) is the penetration efficiency factor. Result: The required explosive charge mass to penetrate 14 cm of a material with a density of 1060 kg/m³ is approximately **2.16 grams**.

Jon Bray

133,285 Aufrufe • vor 8 Monaten

Jon, Before we get to the math on the charge dimensions you just described, and how they are missing 12+% of the explosives you claim went off, we are going to talk about why you keep changing things up. 24 hours ago, you claimed the 0.5 gram "would be a 10mm x 15mm charge" (see first video)! 12 hours later, you claimed the charge was 7.0 mm x 7.34 mm (shocking, I know). Of course, this was after I pointed out how absurdly too large that would be for 0.5 grams of PETN. The problem you can not change Since you changed the charge size in your response, I figured I would point out the obvious gaslighting to the world. 1st, as previously noted, the optimum standoff distance is 1.5x the diameter of the cone. In the case of the last dimensions you provided, the standoff distance would be about 11 mm, which you factored into your devices overall size. So this is my question for you Jon (and all of your wisdom). With the expected penetration (EP) only 1/2 the diameter of the cone, why is it positioned so far back in the device in your diagram? Someone who built such a sophisticated charge would certainly be able to rearrange the internals to give it a snowballs chance in hell of actually working, right? Even with 3x the distance of the EP away from the end of the device dimension you provided, the theoretical jet would be extremely dissipated and STILL INSIDE THE MIC! By the time it leaves the device and hits the air outside, it would be almost totally, if not completely dissipated. So, why would you place it so far back if you ACTUALLY KNEW how this charge worked? Simply put, the explosive charge properly placed int he device wouldn't need a built in standoff. New Dimensions Are Still 12% Cubic Inches Short For 0.5 grams of PETN In your attempt to correct yourself before being further exposed, you forgot to take into account the empty space of the cone leaving you 12% worth of explosives short for a 0.05 gram charge. That is very significant, especially for a charge this size. See graph paper image with all the math. SUMMARY 1. You changed the charge dimensions in the same day 10mm x 15mm -> 7.34 mm x 7.0 mm 2. Second set of charge dimensions you gave yesterday are 12% shy for 0.5 grams of PETN. 3. At 3x max optimal distance for EP of 3.7 mm, you are still inside the mic and the jet would be worthless by the time it exited. 4. Charge placement and why you decided it needed an internal standoff to begin with. All of these point to one thing. You continue to pull this out your butt. Thank you for your attention on this matter.

Matt Tardio

35,788 Aufrufe • vor 15 Tagen

THE TRUTH ABOUT PYRAMIDS The Pyramids were a source of ancient free energy. Ancient civilizations understood the Earths energy function. Our understanding of the ancient civilizations discovery of electricity could very well be wrong. The Giza pyramid was made with granite and limestone. Granite is a conductive stone when exposed to heat, pressure, and water. Limestone is semi conductive. When a sandstorm occurs the pyramids would have been hit with positive charged sand and would have created extreme amounts of electrostatic energy flowing through the limestone charging it with electrons, because it is a semi conductor, right into the granite which has a positive charge and into the conductive granite. Granit is more conductive but has a positive charge so it would not build the same level of static charge as the limestone. Limestone is also know to have a certain level of thermal resistance that could prevent the pyramid from giving off excess heat. Also within the lower chambers of the Pyramid they found copper wire. This could've been used to channel the energy into the sarcophagi. Which some have speculated these granite blocks could've been primitive batteries/capacitators. Wire isn't needed since granite sufficiently charges the air within. It could've been used to ionize the air to create a conductive plasma shooting it to other pyramids with the pyramids that act as receivers with gold capstones to conduct the ionic beams. This free energy system would've sent energy up through the air rather than using wires. The theory is that desert pyramids built out of granite and limestone would've produced the energy while other pyramids would receive the energy. THINK WORLDWIDE. Some estimate this would measure more than 100,000 volts electricity PER METER in sandstorms.

Redpill Drifter

57,908 Aufrufe • vor 1 Jahr

THE HOLY TRINITY IS DIELECTRICITY, MAGNETISM & ELECTRICITY Dielectricity is the Aether and was taking out of scientific literature at the beginning of the 20th century following the removal of Aether from the periodic table of elements. Today most electricians have never heard of dielectricity. What's electricity? Electricity is a hybrid of magnetism and mitters dielectricity. Magnetism and dielectrictricity achieve charge aka electrification through abrasion, friction, pressure and suction. This charge is split into + and - charges. Positive charges are attracted to negative charges. When charge moves from + to - it creates a current like a battery or circuit. The atmosphere is positively charged contrast to the earth which maintains a negative charge. Positive charges correlates with the Masculine and Negative charges correlated with the Feminine. Now you get why ancient cultures refer to the Sky as Father Sky and the Earth as Mother Earth. Father sky donates electrons (charge) to Mother Earth who receives them. This creates fertility in the soil and an atmosphere rich in plasma charge. Viktor Schauberger spoke on how during the times when the ancient forest were thriving the air was so highly charged that plasma sparks could be seen discharging from pine needles and the tips of branches. How do you think atoms are held together ? Electrical Charge. What dictates the health of a cell? Electrical Charge. Electricity correlates with the Physical while Magnetism correlates with the Spiritual. As above, So Below. ✨🙌🏾💫 © nuatlantis

🧬Maxpein🧬

115,578 Aufrufe • vor 1 Jahr

THE HOLY TRINITY IS DIELECTRICITY, MAGNETISM & ELECTRICITY Dielectricity is the Aether and was taking out of scientific literature at the beginning of the 20th century following the removal of Aether from the periodic table of elements. Today most electricians have never heard of dielectricity. What's electricity? Electricity is a hybrid of magnetism and mitters dielectricity. Magnetism and dielectrictricity achieve charge aka electrification through abrasion, friction, pressure and suction. This charge is split into + and - charges. Positive charges are attracted to negative charges. When charge moves from + to - it creates a current like a battery or circuit. The atmosphere is positively charged contrast to the earth which maintains a negative charge. Positive charges correlates with the Masculine and Negative charges correlated with the Feminine. Now you get why ancient cultures refer to the Sky as Father Sky and the Earth as Mother Earth. Father sky donates electrons (charge) to Mother Earth who receives them. This creates fertility in the soil and an atmosphere rich in plasma charge. Viktor Schauberger spoke on how during the times when the ancient forest were thriving the air was so highly charged that plasma sparks could be seen discharging from pine needles and the tips of branches. How do you think atoms are held together ? Electrical Charge. What dictates the health of a cell? Electrical Charge. Electricity correlates with the Physical while Magnetism correlates with the Spiritual. As above, So Below. ✨🙌🏾💫 © nuatlantis

🧬Maxpein🧬

35,868 Aufrufe • vor 3 Monaten