Same capentry tip but different level of expertise.

The speed square one was violence. You’re never using my tools.

No framer carries around a drill. Screws are not meant for framing. A real framer could do this with nails and a nail gun. Show that and then I will be impressed. This is just framing for Instagram.

Who frames with screws?

Nice way to bend your speed square.

So stupid. Been trade journeyman carpenter my entire life. Id be fired if i wasted time like this.

Drill in one hand, joist in the other.....what is this faggetry??

1. NO REAL FRAMER USES SCREW 2. USE YOUR FUCKING HAND TO LEVEL IT THEN NAIL GUN

I’m going to assume he’s using screws to hold it in place until he can nail or install joist hangers. Otherwise that is a flaming code violation

Just hold it.. or put something under it.

I just use my hand and hold it in place.

someone needs to tell this dimbulb about joist hangers.

Or just hold it

Well that square is worthless now. Will bend it.

What nonsense….

Stand over it, use claws of hammer to lift subflush stud, step on it to push down high ones and your framed in minutes. No need to screws or use addition gimmicks.

I’ve indirectly done that before, smart tip

And it takes 5X as long to build it out. Sometimes you just need accuracy and not precision.

People - use your shit aluminum speed square from Home Depot like this and the next time you go to use it for its intended purpose it won’t work.

dont bend your square, dont bother with a screw. just put your bar or the claw of your hammer underneath and lever it up

You don’t frame with screws 🫤

Should’ve just used a nail gun.

That poor speed square

Waste of time get them off my site

How to destroy a square 101 idiots

You could literally just pick it up with your other hand

i make video to show how i figured out how to use hammer in my life... durka get the fuck outta here, invent it first

Total waste of time. if you had an $8 prybar you would have been done by now

Nah, more like what you have available in your bags💯

8 penny nail and your cats paw. You need to use your hamner to drive the 16 penny through the plate.

ダメな見本🙅

I have that Makita driver. It’s the perfect balance between weight and power. Makita ftw

この手のスキルがよく出てくるけどさ.... 余分な穴は開けたくないんだよね

Now do the one when you use your hand, a nail gun, and instead of shooting the bottom first you decide to shoot top, and the 3"spike curls into your finger.

you are not a carpenter.

They all work.. depends on what you're used to... my buddy would be faster all day with the hammer