Skip navigation
Step-by-step how to make a wrapped loop with wire
0:00

Step-by-step how to make a wrapped loop with wire

#howtomakejewelleryathome #howtomakejewelryathome #wirewrapping

Step-by-step how to make a wrapped loop with wire 1. Start by bending the wire to a sharp 90° angle. This gives you a precise anchor for the loop. 2. Place the bend right at the tip of your round-nose pliers, holding it with the top jaw. 3. Roll the wire up and over the jaw to form a circle, wrapping until the wire crosses over itself on the opposite side. 4. Release the pliers, then re-grip the unfinished loop with the bottom jaw. Pull the tail wire across so it crosses over the standing wire at the neck of the loop. 5. Switch to chain-nose (flat-jaw) pliers to hold the loop firmly in place. This keeps everything stable while your other hand does the wrapping. With the loop held steady, coil the tail wire tightly around the neck two or three times, working downward. 6. Trim the excess flush with wire cutters, cutting as close to the last wrap as possible. 7. Finally, press the cut end flat against the coil with your pliers so no sharp edge is left sticking out. 😁 HAPPY CRAFTING! #howtomakejewelleryathome #howtomakejewelryathome #wirewrapping Music license W4VUMKZLD6YIEQVP

Comments

Comments from the original post on Instagram

No comments yet