This guy just found out he’s been using the screen door stopper wrong his entire life...
@end3of6days9124K followers
2,661,738 views
32 Comments
Comments from the original post on X (Twitter)

@MrEncouragement
Not the way it's meant to be done. It holds the door only in that one position. Using it the correct way, the way this guy was previously using it, allows you to hold the door open at any angle.
556 likes

@MidWesterner007
@iamnobody1961 This only works if your support was mounted weird. Most don't even get close to door edge.
424 likes

@KittyLegree
STOP We have all been using it as intended. This little “hack” will disappoint you, because it’s NOT the correct way to keep the door open. It will slip, and the door will close. I seent it
233 likes

@mikesum32
Putting the stopper against the door is the wrong way.
143 likes

@RayMartin79059
This is idiotic. The closer mechanism won't last a year if you do this - the leverage of the back of the door will pull the closer mounting bracket and tear it out of the door jam. Stupid is as stupid does...
113 likes

@ganktor
This is wrong and stupid. Read the instructions if you don't believe me.
72 likes

@PatriotJack76
The “right way” shown in this video will damage your door.
62 likes

@BKR1988NE
No, it goes all the way to the piston. The stopper on my door doesn't even come close to the door.
61 likes

@7279616E
Per this manufacturer, the instructions say the washer should be moved behind the cylinder, not this nonsense. "To hold the door in the open position using a standard closer, open the door and slide the washer along the closer rod until it is located behind the closer cylinder. When the door panel is released, the cylinder will rest against the washer to hold the door in the open position."
47 likes

@PatriotKids
@RealLPoslaiko Never take advice from Nigel
46 likes

@Azraels_Brother
I'm 61. This is me right now
44 likes

@Jonny__OK
Why would you want to leave a screen door open? Most people leave the main door open, keep the screen door closed and allow for air flow into the house. Is this bait? Lmfaoo
30 likes

@SpeakSlowly2Me
I would rather use the "stop" against the cylinder than to place this load against the door itself which might slowly tear the door up. The load is applied to the door through the screws holding the cylinder to the door instead of directly to the door edge each time as shown in the vid...
26 likes

@BillGabriel2
Wow! 6 F-bombs in 30 seconds. Completely unnecessary.
25 likes

@c0rieFontenot
That will dent the door over time !
11 likes

@dave_capt825
It wouldn't work on a wooden door. The lock tab would gouge and splinter a wood door.
11 likes

@JoshWalkos
Either way works 🤷♂️
9 likes

@JimHendley4NC
Oh damn. I’m now having to rethink EVERYTHING!
8 likes

@CitizenNobody1
Amazing how learning something later than your grade school age constitutes several “ WTF’s”. Guess this guy and every other dork that posts the same exact expletive laced videos when they learn their next “life changing hack” assumes all learning has stopped for them after school. Honestly probably had stopped for the most part 😒
8 likes

@Impaleher88
Holy fuckin shit, I've literally never seen anybody doit that way 😂😂
8 likes












