Peter

@Peter05704721 • 1,657 subscribers

Passionate about programming, focused on hardware and software development.

Shorts

Reworked the FPV PCB. Gave GPT-6 Astra a few clean reference boards, then redid IC placement and routing. V1 → V2 below. Ordering the board now.

Reworked the FPV PCB. Gave GPT-6 Astra a few clean reference boards, then redid IC placement and routing. V1 → V2 below. Ordering the board now.

84,438 次观看

People said my last AI PCBs were too simple. So I’m letting GPT-6 Astra build a quadrotor end to end. PCB in EasyEDA. Frame in Fusion 360. 3D-printed arms. Firmware. Camera. Goal: Astra designs it, flies it, and explores the world with its own eyes. V1 PCB is done. Video below.

People said my last AI PCBs were too simple. So I’m letting GPT-6 Astra build a quadrotor end to end. PCB in EasyEDA. Frame in Fusion 360. 3D-printed arms. Firmware. Camera. Goal: Astra designs it, flies it, and explores the world with its own eyes. V1 PCB is done. Video below.

83,065 次观看

Claude Opus 5.5 dropped yesterday. Today I used it with tscircuit to rebuild my FPV flight controller. Same board, different toolchain.

Claude Opus 5.5 dropped yesterday. Today I used it with tscircuit to rebuild my FPV flight controller. Same board, different toolchain.

47,125 次观看

PCB and enclosure both from GPT-6 Astra. Board arrived, case printed, assembled — powered on first try. Only miss: the 3D model’s power-switch cutout is wrong — button won’t press once it’s in the shell. Left it as-is for consistency. Switching with a screwdriver for now. Annoying, but it works. Photos + video below.

PCB and enclosure both from GPT-6 Astra. Board arrived, case printed, assembled — powered on first try. Only miss: the 3D model’s power-switch cutout is wrong — button won’t press once it’s in the shell. Left it as-is for consistency. Switching with a screwdriver for now. Annoying, but it works. Photos + video below.

13,278 次观看

Videos

Anya Rossi

sweetdream.ai

SweetDream.ai•Sponsored•Livecam

Watch Anya Live

Anya is streaming live right now! Join her private show and enjoy exclusive content.

Exclusive private shows

1.2k viewers online

Private Show

Join now for exclusive access

Free preview available • Premium content

Fed GPT-6 Astra my PCB models. It designed the wearable enclosure in Fusion 360. Two boards, a battery, an external power button, magnets to clip it on clothes. Next: 3D print, PCBA, then power it on for real.

Fed GPT-6 Astra my PCB models. It designed the wearable enclosure in Fusion 360. Two boards, a battery, an external power button, magnets to clip it on clothes. Next: 3D print, PCBA, then power it on for real.

152,201 次观看 • 1 个月前

没有更多内容可加载