Загрузка видео...

Не удалось загрузить видео

На главную

Every man lives two lives. The second begins when he realises that he can max out hypertrophy in 15 second sets. The only reps that build muscle are the last 4 to 5 before failure. That's where the bar slows involuntarily, where high-threshold motor units are finally recruited, where...

112,723 просмотров • 4 месяцев назад •via X (Twitter)

Комментарии: 0

Нет доступных комментариев

Здесь появятся комментарии из оригинального поста

Похожие видео

When you train in the 10-12 rep range, most of your reps have no direct effect on growth. When you train in the 4-6 range, virtually all of your reps are growth reps. Both ranges can build muscle. The mechanism doesn't care about the rep count. It cares about how close you get to true failure on the reps where the high-threshold motor units are recruited and every available fibre is firing. Those are the stimulating reps. Everything else is filler. The catch with 10-12 is twofold. First, only the last 4-5 reps in a 12-rep set are actually stimulating. The first seven are buffer. They generate fatigue, lactic acid, and joint wear that the muscle has to push through before any growth signal arrives. Effort, yes. Stimulus, no. Second, and this is where the high-rep crowd quietly come undone: the long set produces so much afferent feedback (burning, gasping, the legs giving a small philosophical speech) that almost nobody actually takes the set to true failure. They stop two, three, sometimes four reps short, mistake the discomfort for the limit, and call it a hard set. The stimulating reps they were chasing never showed up. A set of 6 doesn't allow that confusion. Failure is mechanical. The weight either moves or it doesn't. No interpretive dance required. You'll grow on 10-12. You'll grow more on 4-6, with less joint wear, less recovery debt, and considerably less guesswork. One range tolerates your mistakes. The other doesn't have room for them.

Sama Hoole

63,040 просмотров • 3 месяцев назад

There is not a muscle on the body that needs high reps to see its best growth. This is basic physiology. Yes, muscles vary in their ratio of slow to fast twitch fibres. It doesn't matter, for two reasons: 1. Slow twitch fibres reach their ceiling early. They are not the limiting factor. 2. As you approach failure, every fibre is recruited regardless. The body does not leave capacity sitting idle when it thinks it's about to fail. Here is what actually drives hypertrophy: involuntary slow contractions. The point in a set where the concentric is grinding, the bar speed is dropping, and the muscle is being forced to recruit everything it has just to complete the rep. That is mechanical tension. That is the growth signal. It only exists in the final five or so reps before failure. Everything before that is your body coasting on the fibres it was already using. Some muscles tolerate high reps better than others. Calves are the classic example. But tolerating junk reps is not the same as benefiting from them. It just means the damage is less visible. The reps are still junk. If you are living in the 8-plus rep range, most of your set is happening nowhere near that zone of involuntary contraction. You are accumulating fatigue, impairing recovery, reducing training frequency, and spending more time under the bar: in exchange for a growth stimulus you could have captured in a fraction of the reps. More reps past the point of failure proximity is not more stimulus. It is just more cost.

Sama Hoole

15,967 просмотров • 4 месяцев назад

Normalise RDL as a main movement. The Romanian Deadlift (RDL) or Heavy Barbell Hip Hinge is a powerhouse exercise that has gained a lot of popularity among strength and conditioning coaches, powerlifters, and bodybuilders alike. This movement is often called an “athlete maker" in my mind due to its ability to build strength, muscle mass, and athleticism in both men and women. One of the primary reasons why the RDL is so effective for athletes is because it is triphasic, for the uninitiated meaning it involves three distinct phases of muscle action: eccentric, isometric, and concentric. During the eccentric phase, the lifter is lowering the weight, which creates tension and stress on the muscles, leading to greater muscle damage and adaptation. The isometric phase occurs when the lifter pauses at the bottom of the lift, holding the weight in a static position, which increases the time under tension and helps to build strength and stability. Finally, during the concentric phase, the lifter raises the weight, activating the muscles in a way that promotes greater hypertrophy. Compared to a traditional deadlift off the floor, the RDL places a greater emphasis on the posterior chain, specifically the proximal hamstring, glutes, and erector spinae muscles. The lift also engages the distal hamstring muscles in a nearly fully extended position, promoting greater muscle activation and strengthening. The RDL is an excellent way to develop strength and hypertrophy in these muscle groups, leading to improved overall athletic performance, including greater power, speed, and explosiveness. Given the numerous benefits of the RDL, it should be a main movement in any training program that aims to improve strength, muscle mass, and overall athletic performance. Incorporating heavy barbell hip hinge movements, such as the RDL, into your training regimen can help to promote better posture, improved mobility, and greater overall strength and athleticism. So, whether you are a powerlifter, bodybuilder, or athlete, consider adding the RDL to your training program to take your strength and athleticism to the next level.

Coach Wayland | Performance Expert | Craftsman

228,142 просмотров • 3 лет назад