Skip navigation
Impossible crane hook repair
0:00 / 5:55

Impossible crane hook repair

Farming Area

@Farming_Area22K followers

Visit on X
221 likesDownloadOriginal post

15,400 views

Impossible crane hook repair

20 Comments

Comments from the original post on X (Twitter)

  • FNU LNU's profile picture

    @SanityReign

    Shittiest weld ever.

    14 likes

  • Farming Area's profile picture

    @Farming_Area

    This is the worst weld ever.

    3 likes

  • Bo A's profile picture

    @BoA97531

    That is the worst repair ever! That repair is not even close to the initial strength of the hook. Correctly you would chamfer the threaded piece at an angle of 45 degrees and then weld it in place with a high strength electrode, then heat treat the hook to 450c for 60 minutes.

    6 likes

  • Betelgeuse02🍻👀's profile picture

    @Beetlegeuse02

    Load test 2 mins later 😂

    2 likes

  • Popeye's profile picture

    @SteveGr15825996

    I'm not sure about that weld. Um...at all.

    1 like

  • Farming Area's profile picture

    @Farming_Area

    Same here, I wouldn’t trust that weld at all.

    1 like

  • CM Burgh's profile picture

    @CMBurgh

    Repairing this Hitch is exactly why loads fail and people get hurt ! Shitty welding. Weak joint absolutely stupid

    1 like

  • EyeThinkGrowEvolve 🌺's profile picture

    @EyeThinkGrow

    I wouldn't trust it.

  • Josep Pujol's profile picture

    @OCalahann

    Measure with a caliper, mark with chalk, and cut with axe blows.

  • jmville's profile picture

    @trooper501

    I have lots of concerns about the repair

  • Slick Willie's profile picture

    @SlickWilly53298

    With a weld like that and no bevel it’s just useless.

  • Farming Area's profile picture

    @Farming_Area

    Ok

  • Le Lwa déchu's profile picture

    @lwadechu

    Very poor machining and wielding, especially for heavy duty crane hook

  • Eric Blair's profile picture

    @captndaa

    Not a crane hook, a pintle hitch you daffy bastard!

  • Farming Area's profile picture

    @Farming_Area

    Haha my bad, I got it wrong 😄

  • John B 🇦🇺's profile picture

    @B577960

    Not one drop of milk lubricant used while on the lathe. Crap weld, I could do better and that ain’t saying much.

  • General Malaise 🤕's profile picture

    @hairy_bones

    🙈

  • Ahmet can Şahin's profile picture

    @Ahmetcnshn86

    İş kazalarının nedenlerine örnek olması için videoyu kaydediyorum

  • Buttered scone on's profile picture

    @SconeOn53847

    You’d be put in jail for this in North America and rightly so, ridiculously dangerous

  • Droy's profile picture

    @Hydroylic

    Shame that the process included the strength and knowledge of a screw cut thread to compromise it all with such a poor weld. The straight bar may not be cast steel like the end piece and therefore dissimilar welding rods with deep penetration and heat treatment should be used.