Land cruiser engine oil filter replacement guide DIY

Stupid over engineered garbage.

You're supposed to tighten that until the threads strip, then back it out a 1/4 turn.

Way to not sell a Land Cruiser. Crossing it off the list.

Auto engineers are the dumbest people walking the planet

This is why people hate engineers.

You don't need to do the first part. Just take the main cap off and dump it out in the pan.

Give us back our spin on filter please.

Piece of junk

Skip the ridiculous step. Dump the filter.

You tighten up the filter to much

You don’t have to flick that o ring out , the drain that attaches grabs the seal out for you when removed

British engineering is the worst!

New cars are such trash...

First time I see this design👍 No oil spill on the driveway mom😅

Does that filter even last anytime?

No gloves Very third world

What a pain in the ass, why don't you just have regular filters like every other car

Why

The main body of the filter always turns. 🙄

Well! Now I just need to buy a Land Cruiser

At first it looks dumb and over engineered. But as I’m watching and realizing, it’s not that difficult and the only thing you’re replacing is some O-rings and the actual filter, it kinda makes sense. Less waste and probably cheaper filter.

As a mechanic I have never seen anyone ever use these. Never ever.

About 3 quarts low.

Just get a jeep.

Not a lot of oil in that motor

Sooo. Question How is this better than a regular mobile 1 filter that I use on my 350 ci v8??

Dealer saves money on serviceable parts, you pay full price...

The only time I wished you were a GM.

wait until that housing wears out. Probably 800 dollars lol.

I bet that Land cruiser's engine was knocking when it came in. That vehicle's lucky if it had 1-2 quart of oil in it before draining it. Those vehicles take between 7-8 quarts. Better document on their receipt that they came in way below.