On the main Shopify sphere, we also wanted dynamic clouds that flow naturally, whirling, forming and…
25.408 görüntüleme
15 Yorum
Yorumlar X (Twitter) üzerindeki orijinal gönderiden alınmıştır

@XorDev
The first step is to start with some good noise. We wanted quality, but we had to be mindful of performance to make this run at 8k 60 fps. Some fractal value noise was used as the base. It's cheaper than Simplex and Perlin noise, but still looks good when layered
7 beğeni

@XorDev
For texturing, we need some lighting. This is done by also sampling the cloud density away from the light and comparing the density: exp(cloud_density - shadow_density). This density can also be used for dropshadowing
7 beğeni

@XorDev
For fluid motion, you could use a Navier Stokes fluid solver, but that is expensive and difficult on a sphere at this resolution. What if there was another way to create turbulence procedurally on the fly? I came up with a new 3D version specifically for spherical surfaces
13 beğeni

@XorDev
The standard method works by adding sine waves in different directions, increasing frequency and decreasing amplitudes: When done enough times, you get convincing fluid motion for in real-time for a tiny fraction of the cost (and no bandwidth limits)
9 beğeni

@XorDev
The sphere problem is that we want to limit the waves to the surface. If the waves push the clouds up and down, the noise and motion will no longer make sense. My solution was to project the waves pack to the sphere surface with each iteration
7 beğeni

@XorDev
From here, it was just a matter of finetuning the amount of fluid motion. Too much leads to stretching, but a moderate amount is perfect. All of this is achieved without calculating pressure or velocity vectors!
7 beğeni

@XorDev
For the finishing touches, I made shifted the noise overtime so that clouds form and dissipate and added glowing borders that illuminate the clouds (mipmapping for diffusion)
27 beğeni

@XorDev
There are many other details I could say, but hopefully that's enough to get some ideas rolling. If there's enough interest, I'll write a tutorial specifically on spherical turbulence. It might need a longer write-up to properly explain
24 beğeni

@JanOrszulik
@Shopify :)
3 beğeni

@XorDev
@Shopify Jan, we were inspired by your globe and clouds. What method do you use?
4 beğeni

@JanOrszulik
@Shopify N/N Flow field values then gets transformed from sphere coords into "world space" and that is fed to volumetric rendering together with density.
2 beğeni

@XorDev
@Shopify I'm curious about performance. I was concerned about using lots of samples or lots of shader passes. What projection do you use for spherical mapping?
2 beğeni

@JanOrszulik
@Shopify 1/2 Amount of shader passes itself generally isn't a problem (most will be during fluid sim and you would have to do something insane for that to have significant impact), I will be eventually migrating rendering to octahedral projection most likely.
2 beğeni

@XorDev
@Shopify At 8k with say 25 samples, it would certainly add up. Maybe you're doing like 4 samples? Equirect currently?
1 beğeni

@JanOrszulik
@Shopify For volumetric rendering? I do up to 64 samples along the ray and up to 5 towards light source. You don't want to run that full res, ideally temporal sampling with reprojection. Modern tech like DLSS can push that near perfection (check Star Citizen). Sim itself is super low res.
3 beğeni