Simple repairing a broken trace

cutting that chunk out seems pretty unnecessary.

really it seems like you don't have any idea about it. I am lying?

@jeanguy372738 why for this screen shot?

i'm gonna assume since the end result wasn't show that this didn't work

really ? ohh next post you will be satisfied🙏

what Do you think about it?

How many layers? No engineer would remove the PCB, he would run the jumpers on the bottom and glue the wires to the board. You only need to apply mask to the exposed solder joints.

4 layers you have to be careful during removing pcb

Why cut so much out?

for connection

You don't really connect things buy cutting them out lol. Now if they needed to cut part out to prevent shorts that would make sense.

Biraz abartmış, sadece kazıyıp köprü atsa yeterliydi..

repairing is it necessary ?

There was no need to cut or break it; simply scraping off the soldered areas would have sufficed. But never mind—the result is successful.

Interesting I always thought the dark was the wires

well done

Repairing vintage is so... feasible. Now imagine the same with a modern board. We would just toss it to the garbage can.

hh yeah it's amazing that's the real meaning of electronics

Yeah this isn’t going to work on a multilayer pcb

really ? keep watching the video you will thank me later

thank you my dear friend

Terrible idea removing the whole corner, what if you severed the traces under near the board, should had just soldered the broken traces with a wire

The best part was not tearing it before sealing it up.

no way that's helpful for you?

@grok would this actually work?

Where the hell was this done? I used to repair the old TVs, the one with all the solder joints. This is just complete out idiotic bullshit.

Damn it that's crazy

yeah, just super glued it back on i'm pretty sure that's the only fix i could think of

yeah i van help you to repair it don't worry

"Simple"

Good

thanks 🙏

Ouh gitu ya

electronic ideas

Hopefully it isn’t a layered circuit board with with multiple traces sandwiched between the layers

… that’s a new one. Be right there

Either you intentionally made an unnecessary cut to farm outrage from people who actually know what they’re doing, or you’re a hack. 🤣

Better hope that’s not a multilayer PCB.

Thats not simple and depends on how many layers that board has

now try that on a 12 layer PCB

Nice work

Warum werden dann soviele Fehler gemacht?

Only works on single layer

This doesn't work with multi layer PCBS with traces in between.

Hope it wasn't dual layerd. -_-

Teknik yang digunakan melibatkan penggunaan kawat tembaga halus sebagai jembatan (jumper) untuk menghubungkan kembali jalur yang terputus. Area yang terbakar atau rusak harus dibersihkan terlebih dahulu, kemudian lapisan penutup tembaga dikikis sebelum kawat disolder ke titik yang tepat untuk memulihkan arus listrik. Penting untuk melakukan inspeksi akhir guna menghindari arus pendek (short circuit) akibat sisa timah solder.

"Simple" 😆