Skip navigation
Stop hacking into newly rendered blockwork with heavy hammers and vibrating sledgehammers that…
0:00 / 1:03

Stop hacking into newly rendered blockwork with heavy hammers and vibrating sledgehammers that…

Qs Lanre 👷🏾‍♂️

@lanrycool3.8K followers

Visit on X
482 likesDownloadOriginal post

761,619 views

Stop hacking into newly rendered blockwork with heavy hammers and vibrating sledgehammers that shatter bricks, fracture structural mortar joints and ruin perfectly plumb walls just to bury a switch box or conduit pipe. ​A professional installation requires a controlled, mechanical approach that keeps wall integrity intact, eliminates wide openings and leaves a clean channel ready for conduits.

8 Comments

Comments from the original post on X (Twitter)

  • Fml's profile picture

    @LEDx2000

    How do you want to get the can into the wall then in new buildings? And in this case it doesn't even look like a new building because usually you install the cans and wires before the walls are finished and painted.

    2 likes

  • HalfBakedMason's profile picture

    @TDotMason

    masonry done right that is not an issue. I will assume that is a basement or bottom floor. the blocks will be filled, have rebar and block locks ... where he is working it is painted so I again will assume if the rest is that far along the masonry will have had a chance to fully cure too

    2 likes

  • 𝐉𝐚𝐤𝐞𝐑𝐚𝐳𝐳's profile picture

    @JakeRazz

    I'm confused is the caption supporting the video or against it

    1 like

  • ❤️Jo ❤️'s profile picture

    @JoSara84

    Quite satisfying to watch

    1 like

  • crapbuster's profile picture

    @crapbuster3

    Link to that first tool?

    1 like

  • Lakritsiputki's profile picture

    @Lakritsiputki

    Vibrating sledgehammers? I suppose a nice gentle breaker is better. No vibration at all.

    1 like

  • Enigma's profile picture

    @Fizlid

    This is equally bad. A good builder knows you don’t need to plaster before you chase the walls. That’s bad sequencing.

    1 like

  • Qs Lanre 👷🏾‍♂️'s profile picture

    @lanrycool

    When you are trying to add a new socket to a room that's already finished and painted, using an SDS box cutter is a lifesaver. Instead of taking a heavy hammer and chisel and shattering the plaster all around the wall, it gives you a clean, precise square hole right above the skirting board without messing up the rest of the wall.