Useful Tricks to Attach and Tighten Tool Handles🔧

to avoid all that trouble...buy a new one

I make a full metal sleeve w/biting 30% depth multipronge claws. That barley fits into the "tool" then a full angled weld. Not going to skip or slip. I've made hundreds for locals. Axes, picks, sledge whatever. Serious use on the job tools, a few for volunteer fire departments.

I just soak my mallets, and brick hammers in a pail of water.

Why is watching this so relaxing?

@Mezhevoy Вот что бывает, когда глупый начинает придумывать необычное решение несуществующей проблемы... Большая часть этих идей развалится после пяти минут работы.

Too many screws in the wood for axe. It will break

African way... lost...

01:27 Haha. He did durability test and he failed 😂

man these hurt to watch

Mi abuelo un día antes de usarlo metía esa parte en agua al otro día la madera estaba esponjada y listo para usarse 🫡

People who does not value this tricks has never liked the tools they are handling.

Does this actually work?

♥️

Consigli tremendi 🫣

If you have a drill just create a hole for the screw on the both side

Comprate uno nuevo rata JAJAJAJA

@XIdioticmoment Toomuch work

🧐🧐🧐

買えや

Ridiculous!

Third world technology....

Qué hermosas todas ésas herramientas q buen ajuste a todas, incluso algunas q ni sé para q son, pero quedaron espectaculares en el refuerzo de las mismas! 👍🏻

Buy a new tool. Your time is minimum 25-35/hr?? This tool costed 75-105 plus convenience tax.

This is undefeated again 🖋This healed a part of me I didn't know needed it for real🌵📓

The last one 😂

Nice

جميل

forgot how much british politics bores me until this thread made me realize i've been skimming