so i bought the macintosh LC
69K followers
62,594 views
40 Comments
Comments from the original post on X (Twitter)

@TracketPacer
side note, recent evidence suggests neurodivergent women experience perimenopause earlier. so if your young & beautiful wife recently began hating you… it might be perimenopause showing her the truth. be better
125 likes

@l0ft1369
girl - right now go and buy this: its exactly what you need
18 likes

@robertgraham
It has "AppleTalk", a 230kbps networking. You can get a AppleTalk-to-Ethernet bridge and get file sharing working on your NAS. This won't do TCP/IP, but will do the older AppleTalk stack. There are also SCSI-to-Ethernet adapters.
13 likes

@dez_blanchfield
you can get a suitable card for the LC to get ethernet btw.. it's called a: Apple Ethernet LC Card 820-0443-B
13 likes

@TracketPacer
thank you!!!!! i so appreciate the guidance 🫡
10 likes

@dez_blanchfield
#TeamEffort :-)

@dez_blanchfield
reach out to Jeremy Barr-Hyde ( DM if you'd like an email introduction from me directly to Jeremy ) and get access to all of his amazing huge Apple Mac good-drive archives of everything you can every want for "retro" Macintosh computers..
11 likes

@TracketPacer
it is really amazing & impressive how much information is kept by folks just… out there over the years. thanks again. will definitely reach out at some point—aggregating info at the moment so will get my bearings and report back
8 likes

@dez_blanchfield
#TeamEffort ;-)
1 like

@Atrium_Arduous
Here... if it hasn't been explained to you simply... Connecting a 1991 Macintosh computer to a modern PC using Ethernet-to-Serial technology requires bridging LocalTalk (serial-based Apple networking) to Ethernet or using a Serial-to-WiFi/Ethernet emulator. Here are the best methods based on 1991-era Mac hardware (typically Macintosh SE/30, IIci, LC, or Classic II): 1. The Recommended Approach: LocalTalk-to-Ethernet Bridge This is the most reliable method for file sharing and networking. Hardware: An AsanteTalk or Farallon EtherMac iPrint Adapter (SL or TL). Method: Plug the 1991 Mac’s Printer/Modem port (Mini DIN-8) into the PhoneNet port of the bridge. Plug an Ethernet cable from the bridge to your modern network/PC. Software: Set AppleTalk to "Active" in the "Chooser" on the Mac. Your modern PC (using software like Netatalk) can then see the Mac. Vintage Computer Federation Forums Vintage Computer Federation Forums +1 2. The Modern Approach: Serial-to-WiFi (TheOldNet) This simulates a modem over WiFi for internet/BBS access. Hardware: A Serial WiFi modem from (usually connects to the modem port). Method: Connect this device via RS232/Mini DIN-8, and it bridges directly to modern WiFi, acting as a Hayes-compatible modem. YouTube YouTube 3. Direct PC-to-Mac Serial Link (Terminal Mode) Using a null-modem cable to transfer files without a network. Hardware: A "Printer Cable" (Mini DIN-8 to DB9 or DB25). Method: Connect the two computers directly. Mac Side: Use terminal software like ZTerm or Kermit. PC Side: Use software like Tera Term. Setup: Set both to the same Baud rate (e.g., 57600) and perform ZMODEM file transfers. YouTube YouTube +4 4. Direct Ethernet (If Equipped) If your 1991 Mac has a PDS Ethernet Card (rare, but available then) or a Quadra/IIci with built-in AAUI. Hardware: An AAUI-15 to 10BaseT Ethernet adapter (transceiver). Method: Plug the transceiver into the Mac, then connect a standard RJ45 cable to a hub or a modern PC. Essential 1991 Mac Software System 7 is recommended for built-in TCP/IP support. MacTCP/Open Transport for IP networking. Fetch or FTP clients for file transfers. Facebook Facebook Note: For the best experience connecting to a modern PC, a Raspberry Pi acting as a PPP/SLiRP server over the Mac’s serial port is a popular modern hobbyist approach.

@dez_blanchfield
@TracketPacer mate, I was using these systems from the day they were released, you're explaining the tech I lived and worked with every day - give me a break..
1 like

@Atrium_Arduous
Lol... sorry man... its just she could probably run a low latency digital conversion silicon chip( a new word: table) to arduino and or hand wire the bridge with serial ends if she wanted which might be fun and funky... as that's kinda round about as you'd have niche and~ a website... haha have a good one!
1 like

@dez_blanchfield
@TracketPacer all good ;-) keep the info coming mate..

@RetroTechorDie
Here is mine with a PDS Ethernet and a Blue SCSI on #globaltalk. Enjoy and get that thing on Global Talk :)
11 likes

@MikeGburzynski
That pristine LC is quite a find. This would be the 68020 so if you can look around and see if you can find the LC II motherboard as it will be a drop in replacement and has the 68030, also a VRAM upgrade. I grew up on this computer lol. The cards use the LC PDS not Nubus.
5 likes

@iunderwood
You don’t have to justify this kind of purchase. Ever. That is an amazing find!
4 likes

@ClassicII_MrMac
Yea!!!!!!!! Looks like it is in perfect shape!🎉🥳 I have no other advice but to enjoy it!
4 likes

@leakyattribute
Ah - appletalk. Something like an asantetalk adapter would do the trick. Might be difficult to get (got one I no longer need - but I can see you're in the US - so pricey to ship) Then you can run appletalk services on linux (netatalk).
3 likes

@DarrellRoot
I think this is the book I used to have on AppleTalk/LocalTalk But even Apple retired AppleTalk from their corporate network (I’d say 😢, except I helped the retirement)
3 likes

@WallyPetersIV
You bought a 35 year old vintage computer in pristine condition and set it up on the floor?
3 likes



















